Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

phone

Configure phone numbers to reach the contact person.

Syntax
phone primary phone [alternate phone]

To remove a phone number, use the no phone command. To remove the primary and alternate phone numbers, use the no phone primary and no phone alternate commands respectively.

Parameters
primary phone
Enter the keyword primary then the primary phone number for the person.
alternate phone
Enter the keyword alternate then the alternate phone number for the person.
Command Modes
SUPPORTASSIST PERSON
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced on the M I/O Aggregator and FN IOM.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
9.9(0.0)
Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON, Z9500, MXL.
Usage Information

The phone numbers may contain country codes, area codes and extensions, if necessary. Allowable characters are 0 to 9, x, (, ), - and +.

This command is optional for SupportAssist service configuration.

Related Commands
  • preferred-method — configure the preferred method for contacting the person.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\