Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

policy-map-output

Create an output policy map.

S4048–ON

Syntax
policy-map-output policy-map-name

To remove a policy map, use the no policy-map-output policy-map-name command.

Parameters
policy-map-name
Enter the name for the policy map in character format (32 characters maximum).
Defaults
none
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Policy name character limit increased from 16 to 32.
7.6.1.0
Introduced on the C-Series and S-Series.
6.1.1.1
Introduced on the E-Series.
Usage Information
To assign traffic to different flows using QoS policy, use the Output Policy map. This command enables Policy-Map-Output Configuration mode (conf-policy-map-out).
Related Commands
  • service-queue — assigns a class map and QoS policy to different queues.
  • policy-aggregate — allows an aggregate method of configuring per-port QoS using policy maps.
  • service-policy output — applies an output policy map to the selected interface.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\