Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

port

Configures NAS port number to accept CoA or DM requests.

Syntax
port port-number

To remove the NAS port configuration, enter the no port command.

Defaults
3799
Parameters
port-number
Enter the NAS port number to accept CoA and DM requests. The range is from 1 to 65535.
Command Modes
  • CONF-DYNAMIC-AUTH
Usage Information
  • Optionally specify dynamic authorization port number. Default port is 3799.
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version
Description
9.14(1.0)
Introduced on the S4810 and S4820T.
9.13(0.0)
Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000, S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and MXL.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\