Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

qos-policy-output ets

To configure the ETS bandwidth allocation and scheduling for priority traffic, create a QoS output policy.

Syntax
qos-policy-output policy-name ets

To remove the QoS output policy, use the no qos-policy-output ets command.

Parameters
policy-name
Enter the policy name. The maximum is 32 characters.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide.

Version
Description
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information

If an error occurs in an ETS output-policy configuration, the configuration is ignored and the scheduler and bandwidth allocation settings are reset to the ETS default values (all priorities are in the same ETS priority group and bandwidth is allocated equally to each priority).

If an error occurs when a port receives a peer’s ETS configuration, the port’s configuration is reset to the previously configured ETS output policy. If no ETS output policy was previously applied, the port is reset to the default ETS parameters.

You can only associate output QoS policy profiles with the priority groups in the DCB output profile context; output QoS policy profiles are not permitted on output policy-maps.

WRED, ECN, rate shaping, and rate limiting are not supported in output policies because DCBx does not negotiate these parameters with peer devices. You can apply a QoS output policy with WRED and/or rate shaping on a DCBx CIN-enabled interface.

If you enable the scheduler command for a QoS ETS output policy, no bandwidth percentage is assigned to the policy.

Related Commands
  • scheduler — schedule the priority traffic in port queues.
  • bandwidth-percentage — bandwidth percentage allocated to the priority traffic in port queues.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\