Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

queue ingress

Assign a WRED Curve to all eight ingress Multicast queues or designate the percentage for the Multicast bandwidth queue.

Syntax
queue ingress multicast {linecard slot number port-set number | all} [wred-profile name]

To return to the default, use the no queue ingress multicast {linecard slot number port-set number | all} [wred-profile name] command.

Parameters
linecard number
Enter the keyword linecard then the line card slot number.
port-set number
Enter the keywords port-set then the line card’s port pipe. The range is from 0 or 1.
all
Enter the keyword all to apply to all line cards.
wred-profile name
(OPTIONAL) Enter the keywords wred-profile then your WRED profile name in character format (16 character maximum). Or use one of the pre-defined WRED profile names.

Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g, wred_teng_y, wred_teng_g.

Defaults
none
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
8.3.19.0
Introduced on the S4820T.
8.3.8.0
Introduced on the S4810.
7.4.1.0 and 6.5.3.0
Introduced on the E-Series.
Usage Information

This command does not uniquely identify a queue, but rather identifies only a set of queues. The WRED Curve is applied to all eight ingress Multicast queues.

NOTE: The multicast-bandwidth option is not supported on queue ingress. If you attempt to use the multicast-bandwidth option, the following reject error message is generated: % Error:Bandwidth-percent is not allowed for ingress multicast.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\