Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

radius dynamic-auth

Enters a new sub-mode, RADIUS-DYNAMIC-AUTH, which enables you to modify dynamic authorization settings.

Syntax
radius dynamic-auth

To remove the dynamic authorization method for RADIUS users, enter the no radius dynamic-auth command.

Defaults
Disabled.
Command Modes
  • CONFIGURATION
Usage Information
  • All dynamic authorization commands are configured by entering this mode.
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version
Description
9.14(1.0)
Introduced on the S4810 and S4820T.
9.13(0.0)
Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000, S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and MXL.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\