Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

redistribute isis

Redistribute IS-IS routing information throughout the OSPF instance.

Syntax
redistribute isis [tag] [level-1 | level-1-2 | level-2] [metric metric-value | metric-type type-value] [route-map map-name] [tag tag-value]

To disable redistribution, use the no redistribute isis [tag] [level-1 | level-1-2 | level-2] [metric metric-value | metric-type type-value] [route-map map-name] [tag tag-value] command.

Parameters
tag
(OPTIONAL) Enter the name of the IS-IS routing process.
level-1
(OPTIONAL) Enter the keywords level-1 to redistribute only IS-IS Level-1 routes.
level-1-2
(OPTIONAL) Enter the keywords level-1-2 to redistribute both IS-IS Level-1 and Level-2 routes.
level-2
(OPTIONAL) Enter the keywords level-2 to redistribute only IS-IS Level-2 routes.
metric metric-value
(OPTIONAL) Enter the keyword metric then a number. The range is from 0 (zero) to 4294967295.
metric-type type-value
(OPTIONAL) Enter the keywords metric-type then one of the following:
  • 1 = for OSPF External type 1
  • 2 = for OSPF External type 2
route-map map-name
(OPTIONAL) Enter the keywords route-map then the name of the route map.
tag tag-value
(OPTIONAL) Enter the keyword tag to set the tag for routes redistributed into OSPF. The range is from 0 to 4294967295.
Defaults
Not configured.
Command Modes
ROUTER OSPF
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Added support for Multi-Process OSPF.
7.5.1.0
Introduced on the C-Series.
pre- 6.1.1.1
Introduced on the E-Series.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\