Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

redundancy disable-auto-reboot

Prevent the system from auto-rebooting the failed module.

Syntax
redundancy disable-auto-reboot stack-unit [stack—unit ID| members} [rpm| card number | all]

To return to the default, use the no redundancy disable-auto-reboot stack-unit rpm command.

Parameters
rpm
Enter the keyword rpm to disable auto-reboot of the failed RPM.
stack-unit
Enter the keyword stack-unit then the stack-unit ID number.
Default
Disabled — the failed module is automatically rebooted.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.3.1.0
Added the all option.
8.1.1.0
Introduced on the E-Series.
7.6.1.0
Introduced on the E-Series
Usage Information
Enabling this command keeps the failed RPM in the failed state. If there are two RPMs in the system, enabling this command prevents the failed RPM from becoming a working Standby RPM. If there is only one RPM in the system, the failed RPM does not recover and affects the system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\