Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

redundancy protocol

Enable hitless protocols.

Syntax
redundancy protocol {lacp | xstp}

To disable a hitless protocol, use the no redundancy protocol {lacp | xstp} command.

Parameters
lacp
Enter the keyword lacp to make LACP hitless.
xstp
Enter the keyword xstp to invoke hitless STP (all STP modes — MSTP, PVST+, RSTP, and STP).
Default
Disabled
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Introduced on the C-Series.
8.1.1.0
Introduced on the E-Series.
7.6.1.0
Introduced on the E-Series.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\