Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

role

Changes command permissions for roles.

Syntax
role mode { { { addrole | deleterole } role-name } | reset } command

To delete access to a command, use the no role mode role-name

Parameters
mode

Enter one of the following keywords as the mode for which you are controlling access:

configure for CONFIGURATION mode

exec for EXEC mode

interface for INTERFACE modes

line for LINE mode

route-map for Route-map mode

router for Router mode

addrole
Enter the keyword addrole to add permission to the command. You cannot add or delete rights for the sysadmin role.
deleterole

Enter the keyword deleterole to remove access to the command. You cannot add or delete rights for the sysadmin role.

role-name
Enter a text string for the name of the user role up to 63 characters. These are 3 system defined roles you can modify: secadmin, netadmin, and netoperator.
reset
Enter the keyword reset to reset all roles back to default for that command. 
command
Enter the command’s keywords to assign the command to a certain access level. You can enter one or more keywords.
Defaults
none
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.0)  
Introduced on the Z9000, S6000, S4820T, S4810, and MXL. 
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\