Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

show hardware ip

Display ACL or QoS data for the selected stack member and stack member port-pipe.

Syntax
show hardware layer3 {acl | qos} stack-unit number port-set 0–0
Parameters
acl | qos
Enter either the keyword acl or the keyword qos to select between ACL or QoS data.
stack-unit number
Enter the keywords stack-unit then a number to select a stack ID.
port-set 0–0
Enter the keyword port-set with a port-pipe number. The range is from 0 to 0.
Defaults
None
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.0
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\