Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

show ip pim interface

View information on the interfaces with IP PIM enabled.

S4048–ON

Syntax
show ip pim [vrf vrf-name] interface
Parameters
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this setting on this VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
Command Modes
  • EXEC
  • EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for VRF. Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
8.1.1.0
Introduced on the E-Series.
7.8.1.0
Introduced on the S-Series.
Usage Information
The following describes the show ip pim interface command shown in the following example.
Field
Description
Address
Lists the IP addresses of the interfaces participating in PIM.
Interface
List the interface type, with either slot/port information or ID (VLAN or Port Channel), of the interfaces participating in PIM.
Ver/Mode
Displays the PIM version number and mode for each interface participating in PIM:
  • v2 = PIM version 2
  • S = PIM Sparse mode
Nbr Count
Displays the number of PIM neighbors discovered over this interface.
Query Intvl
Displays the query interval for Router Query messages on that interface (configured with ip pim query-interval command).
DR Prio
Displays the Designated Router priority value configured on the interface (use the ip pim dr-priority command).
DR
Displays the IP address of the Designated Router for that interface.

The show ip pim interface command does not display information corresponding to the loop-back interfaces.

Example
DellEMC# show ip pim interface
Address          Interface Ver/   Nbr    Query  DR       DR
                           Mode   Count  Intvl  Prio
165.87.34.5      Te 1/10   v2/S   0      30     1        165.87.34.5
10.1.1.2         Vl 10     v2/S   1      30     1        10.1.1.2
20.1.1.5         Vl 20     v2/S   1      30     1        20.1.1.5
165.87.31.200    Vl 30     v2/S   1      30     1        165.87.31.201
DellEMC#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\