Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

show ipv6 cam stack-unit

Displays the IPv6 CAM entries for the specified stack-unit.

Syntax
show ipv6 cam [vrf vrf-name] stack-unit unit-number port-set {0-1} [summary | index | ipv6 address]
Parameters
vrf vrf-name
(Optional) Enter the keyword vrf followed by the name of the VRF to display IPv6 CAM entries corresponding to that VRF.
NOTE: If you do not specify this option, IPv6 CAM entries corresponding to the default VRF are displayed.
unit-number
Enter the stack unit’s ID number.
port-set
Enter the keyword Port Set.
summary
(OPTIONAL) Enter the keyword summary to display a table listing network prefixes and the total number prefixes which can be entered into the IPv6 CAM.
index
(OPTIONAL) Enter the index in the IPv6 CAM.
ipv6-address
Enter the IPv6 address in the x:x:x:x::x/n format to display networks that have more specific prefixes. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Defaults
None
Command Modes
  • EXEC
  • EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for VRF.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.3.7.1
Introduced on the S4810.
8.4.2.1
Introduced on the S-Series.
Usage Information
NOTE: If a route has a mask greater than 64, no output is displayed and no output is displayed for show ipv6 cam stack-unit unit-number port-set {0-1} ipv6-address, but an equivalent /64 entry would be listed in the show ipv6 cam stack-unit unit-number port-set {0-1} output. Similarly, if there is more than one ECMP object with a destination route that has a mask greater than 64, if the first 64 bits in the destination routes of the ECMP objects are the same, only one route is installed in CAM even though multiple ECMP path entries exist.
NOTE: The self address is displayed in the neighbor portion for the show ipv6 cam stack-unit unit-number port-set command.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\