Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

show vxlan vxlan-instance

Displays information related to Network Virtualization Overlay (NVO) Gateway.

Syntax
show vxlan vxlan-instance instance ID
Parameters
instance ID
Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the initial release.
Command Modes
  • EXEC

  • EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced the static mode on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON, and Z9100–ON.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100–ON.
9.10(0.1P10)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S4048–ON.
9.7(0.0)
Introduced on the S6000-ON.
9.4(0.0)
Introduced on the S6000.
Example
DellEMC#show vxlan vxlan-instance 1
Instance        : 1
Admin State     : enabled
Management IP   : 192.168.200.200
Gateway IP      : 3.3.3.3
MAX Backoff     : 30000
Controller 1    : 192.168.122.6:6632 ssl (connected)
Fail Mode       : secure
Port List       :
  Fo 1/49    Te 1/16   Te 1/20   Po 2
Related Commands
vxlan-instance- Enable VXLAN Instance configuration on the platform.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\