Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

stack-unit stack-group

Configure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure the unit is assigned to the correct group.

Syntax
stack-unit unit-id stack-group stack-group-id

To remove the current stack group configuration, use the no stack-unit unit-id stack-group stack-id command.

Parameters
unit-id
Enter the stack unit ID.
stack-group-id
Enter the stack group ID.
Defaults
none
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide.

Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.7.1
Introduced on the S4810.
8.3.12.0
Reset command mode from EXEC to CONFIGURATION.
Usage Information
The following message displays to confirm the command.
Setting ports Fo 1/60 as stack group will make their interface configs obsolete after a reload.[confirm yes/no]: If “y” is entered, all non-default configurations on any member ports of the current stack group will be removed when the unit is rebooted.
NOTE: Any scripts used to streamline the stacking configuration process must be updated to reflect the Command Mode change from EXEC Privilege to CONFIGURATION to allow the scripts to work correctly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\