Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

track ip host reachability

Configure object tracking on the reachability of an IPv4 host.

Syntax
track object-id ip host host-ip-address/prefix-len reachability [vrf vrf-name]

To return to the default setting, use the no track object-id command.

Parameters
object-id
Enter the ID number of the tracked object. The range is 1 to 500.
ip-address/ prefix-len
Enter an IPv4 address in dotted decimal format. The valid IPv4 prefix lengths are from /0 to /32.
vrf vrf-name
(Optional) You can configure a VPN routing and forwarding (VRF) instance to specify the virtual routing table to which the tracked route belongs.
Defaults
None
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S4820T, S4810, S6000, S5000, Z9000, Z9500, IOA, and MXL.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\