Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

udf-id

Assign value for each configured UDF ID in the given UDF TCAM profile.

Syntax
udf-id id value mask

To return to the default settings, use the no udf-id 1-12 value mask command.

Parameters
id
Enter the UDF ID range. The range is from 1 to 12.
value
Enter the value for the UDF in Hex, up to 24 bytes.
mask
Enter the mask for the UDF in Hex, up to 24 bytes.
Defaults
None
Command Modes
CONFIGURATION-UDF-Qualifier-Value Profile
Example
Dell(conf-udf-tcam-qual-val)#udf-id 1 aa ff
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version
Description
9.8(0.0)
Introduced on the S6000, Z9500, and S4048-ON.
Related Commands

udf-qualifier-value — creates a UDF qualifier value.

udf-tcam — creates a context for UDF TCAM.

show config — displays the current UDF -Qualifier-Value Profile configuration.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\