Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

udf-qualifier-value

Create a UDF qualifier value to assign values for all UDF IDs.

Syntax
udf-qualifier-value name

To return to the default settings, use the no udf-qualifier-value name command.

Parameters
name
Enter the UDF qualifier value profile name, up to 64 characters.
Defaults
None
Command Modes
CONFIGURATION-UDF TCAM
Example
Dell(conf-udf-tcam)# udf-qualifier-value ipnip_val1
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version
Description
9.8(0.0)
Introduced on the S6000, Z9500, and S4048-ON.
Related Commands

udf-id — assigns value for each configured UDF ID in the given UDF TCAM profile.

udf-tcam — creates a context for UDF TCAM.

show config — displays the current UDF-Qualifier-Value Profile configuration.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\