Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

udf-tcam

Create a context for UDF TCAM.

Syntax
udf-tcam name seq number

To return to the default settings, use the no udf-tcam name seq number command.

Parameters
name
Enter the UDF ACL profile name, up to 64 characters.
number
Enter the keyword seq then the sequence number of the Udf-Tcam table. The range is from 1 to 512.
Defaults
None
Command Modes
CONFIGURATION
Example
Dell(conf)#udf-tcam ipnip seq 1
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version
Description
9.8(0.0)
Introduced on the S6000, Z9500, and S4048-ON.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\