Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

upgrade system stack-unit

Copy the boot image or Dell EMC Networking OS from the management unit to one or more stack members.

Syntax
upgrade {boot | system} stack-unit {all | stack-unit-number | A | B}
Parameters
boot
Enter the keyword boot to copy the boot image from the management unit to the designated stack members.
system
Enter the keyword system to copy the Dell EMC Networking OS image from the management unit to the designated stack members.
stack-unit
Enter the stack-unit number. The range is from 1 to 6.
all
Enter the keyword all to copy the designated image to all stack members.
A
Enter the keyword A to upgrade all stacked units in System A ( only).
B
Enter the keyword B to upgrade all stacked units in System B ( only).
Defaults
none
Command Modes
EXEC
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(2.0)
Introduced on the S3100 series.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
Usage Information
To reboot using the new image, use the upgrade boot system stack-unit command.
Related Commands
  • reload — reboots Dell EMC Networking OS.
  • reset stack-unit — resets the designated stack member.
  • show system — displays the status of all stack members or a specific member.
  • show version — displays the current Dell EMC Networking OS version information on the system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\