Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

vxlan-instance static

Enable VXLAN instance configuration to be static on the platform.

Syntax
vxlan-instance instance ID [static]

To delete VXLAN instance from the system, use no vxlan-instance instance ID command.

Parameters
instance ID
Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the initial release.
static
Enter the keyword static to set the VXLAN instance in static mode.
Defaults
Controller mode.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON, and Z9100–ON.
Usage Information

By default, VXLAN instance is created in controller mode. You need a controller to configure VTEP. When you create VXLAN instance in static mode, you can configure VTEP through CLIs.

Use the no shutdown command to enable the VXLAN instance.

Only one VXLAN instance can exist in a system.

You cannot modify a VXLAN instance mode. If you need to change the mode, you can delete the existing VXLAN instance and create a new instance with the required mode.

Example

Enable VXLAN instance:

DellEMC(conf)#feature vxlan
DellEMC(conf)#vxlan-instance 1 static
DellEMC(conf-vxlan-inst-1)#no shutdown

Disable VXLAN instance:

DellEMC(conf)#no vxlan-instance 1 static

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\