Dell Command Line Reference Guide for the S4048–ON System 9.14.2.4

PDF

vxlan-instance

Enable VXLAN Instance configuration on the platform.

Syntax
vxlan-instance instance ID [nsx | nuage | static]

To delete vxlan-instance from the system, use no vxlan-instance instance ID command.

Parameters
instance ID
Enter the VXLAN instance ID. The platform supports only the instance ID 1.
nsx
Enter the keyword nsx to connect to an NSX controller.
NOTE: When no keyword is specified, the nsx option is applied.
nuage
Enter the keyword nuage to connect to a Nuage controller.
static
Enter the keyword static to configure static VXLANs.
Defaults
Disabled
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(0.0)
Introduced nsx and Nuage keywords on the S5048F–ON.
9.13(0.0)
Introduced nsx and Nuage keywords on the S4048–ON, S4048T-ON, S6000, S6000–ON, S6100–ON, S6010–ON, and Z9100–ON.
9.12(1.0)
Introduced on the S5048F–ON.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100–ON.
9.10(0.1P10)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S4048–ON.
9.7(0.0)
Introduced on the S6000-ON.
9.4.(0.0)
Introduced on the S6000.
Usage Information
You must configure VXLAN globally before using VXLAN-instance. Use the no shutdown command to enable the VXLAN instance.
Example

Enable VXLAN instance:

DellEMC(conf)#int 1/5/1
DellEMC(conf-if-te-1/5/1)#vxlan-instance 1
DellEMC(conf-if-te-1/5/1-vxlan-inst-1)#no shutdown

Disable VXLAN instance:

DellEMC(conf)#no vxlan-instance 1
Related Commands
feature vxlan — Enable VXLAN configuration globally on the platform.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\