Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Configuration Guide for the S4048–ON System 9.14.2.4

PDF

Assigning IP Addresses to an Interface

Assign primary and secondary IP addresses to physical or logical (for example, [virtual local area network [VLAN] or port channel) interfaces to enable IP communication between the system and hosts connected to that interface.

You can assign one primary address and up to 255 secondary IP addresses to each interface.
  1. Enter the keyword interface then the type of interface and slot/port[/subport] information.
    CONFIGURATION mode
    interface slot/port[/subport]
    • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
    • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
    • For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
    • For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port information.
    • For a port channel interface, enter the keywords port-channel then a number.
    • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
  2. Enable the interface.
    INTERFACE mode
    no shutdown
  3. Configure a primary IP address and mask on the interface.
    INTERFACE mode
    ip address ip-address mask [secondary]
    • ip-address mask: the IP address must be in dotted decimal format (A.B.C.D). The mask must be in slash prefix-length format (/24).
    • secondary: add the keyword secondary if the IP address is the interface’s backup IP address. You can configure up to eight secondary IP addresses.

Example the show config Command

To view the configuration, use the show config command in INTERFACE mode or use the show ip interface command in EXEC privilege mode, as shown in the second example.
DellEMC(conf-if)#show conf
!
interface TenGigabitEthernet 1/1
  ip address 10.11.1.1/24
  no shutdown
!

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\