Dell Configuration Guide for the S4048–ON System 9.14.2.4

The following table lists the CLI mode, its prompt, and information about how to access and exit the CLI mode. Move linearly through the command modes, except for the end command which takes you directly to EXEC Privilege mode and the exit command which moves you up one command mode level.

Table 1. Dell EMC Networking OS Command ModesCommand Modes

CLI Command Mode	Prompt	Access Command
EXEC	DellEMC>	Access the router through the console or terminal line.
EXEC Privilege	DellEMC#	From EXEC mode, enter the enable command. From any other mode, use the end command.
CONFIGURATION	DellEMC(conf)#	From EXEC privilege mode, enter the configure command. From every mode except EXEC and EXEC Privilege, enter the exit command.
NOTE Access all of the following modes from CONFIGURATION mode.
AS-PATH ACL	DellEMC(config-as-path)#	ip as-path access-list
10 Gigabit Ethernet Interface	DellEMC(conf-if-te-1/1)#	interface (INTERFACE modes)
40 Gigabit Ethernet Interface	DellEMC(conf-if-fo-1/52)#	interface (INTERFACE modes)
Interface Group	DellEMC(conf-if-group)#	interface(INTERFACE modes)
Interface Range	DellEMC(conf-if-range)#	interface (INTERFACE modes)
Loopback Interface	DellEMC(conf-if-lo-0)#	interface (INTERFACE modes)
Management Ethernet Interface	DellEMC(conf-if-ma-1/1)#	interface (INTERFACE modes)
Null Interface	DellEMC(conf-if-nu-0)#	interface (INTERFACE modes)
Port-channel Interface	DellEMC(conf-if-po-1)#	interface (INTERFACE modes)
Tunnel Interface	DellEMC(conf-if-tu-1)#	interface (INTERFACE modes)
VLAN Interface	DellEMC(conf-if-vl-1)#	interface (INTERFACE modes)
STANDARD ACCESS-LIST	DellEMC(config-std-nacl)#	ip access-list standard (IP ACCESS-LIST Modes)
EXTENDED ACCESS-LIST	DellEMC(config-ext-nacl)#	ip access-list extended (IP ACCESS-LIST Modes)
IP COMMUNITY-LIST	DellEMC(config-community-list)#	ip community-list
AUXILIARY	DellEMC(config-line-aux)#	line (LINE Modes)
CONSOLE	DellEMC(config-line-console)#	line (LINE Modes)
VIRTUAL TERMINAL	DellEMC(config-line-vty)#	line (LINE Modes)
STANDARD ACCESS-LIST	DellEMC(config-std-macl)#	mac access-list standard (MAC ACCESS-LIST Modes)
EXTENDED ACCESS-LIST	DellEMC(config-ext-macl)#	mac access-list extended (MAC ACCESS-LIST Modes)
MULTIPLE SPANNING TREE	DellEMC(config-mstp)#	protocol spanning-tree mstp
Per-VLAN SPANNING TREE Plus	DellEMC(config-pvst)#	protocol spanning-tree pvst
PREFIX-LIST	DellEMC(conf-nprefixl)#	ip prefix-list
RAPID SPANNING TREE	DellEMC(config-rstp)#	protocol spanning-tree rstp
REDIRECT	DellEMC(conf-redirect-list)#	ip redirect-list
ROUTE-MAP	DellEMC(config-route-map)#	route-map
ROUTER BGP	DellEMC(conf-router_bgp)#	router bgp
BGP ADDRESS-FAMILY	DellEMC(conf-router_bgp_af)# (for IPv4) DellEMC(conf-routerZ_bgpv6_af)# (for IPv6)	address-family {ipv4 multicast | ipv6 unicast} (ROUTER BGP Mode)
ROUTER ISIS	DellEMC(conf-router_isis)#	router isis
ISIS ADDRESS-FAMILY	DellEMC(conf-router_isis-af_ipv6)#	address-family ipv6 unicast (ROUTER ISIS Mode)
ROUTER OSPF	DellEMC(conf-router_ospf)#	router ospf
ROUTER OSPFV3	DellEMC(conf-ipv6router_ospf)#	ipv6 router ospf
ROUTER RIP	DellEMC(conf-router_rip)#	router rip
SPANNING TREE	DellEMC(config-span)#	protocol spanning-tree 0
TRACE-LIST	DellEMC(conf-trace-acl)#	ip trace-list
CLASS-MAP	DellEMC(config-class-map)#	class-map
CONTROL-PLANE	DellEMC(conf-control-cpuqos)#	control-plane-cpuqos
DHCP	DellEMC(config-dhcp)#	ip dhcp server
DHCP POOL	DellEMC(config-dhcp-pool-name)#	pool (DHCP Mode)
ECMP	DellEMC(conf-ecmp-group-ecmp-group-id)#	ecmp-group
EIS	DellEMC(conf-mgmt-eis)#	management egress-interface-selection
FRRP	DellEMC(conf-frrp-ring-id)#	protocol frrp
LLDP	DellEMC(conf-lldp)# or DellEMC(conf-if—interface-lldp)#	protocol lldp (CONFIGURATION or INTERFACE Modes)
LLDP MANAGEMENT INTERFACE	DellEMC(conf-lldp-mgmtIf)#	management-interface (LLDP Mode)
LINE	DellEMC(config-line-console) or DellEMC(config-line-vty)	line console orline vty
MONITOR SESSION	DellEMC(conf-mon-sess-sessionID)#	monitor session
OPENFLOW INSTANCE	DellEMC(conf-of-instance-of-id)#	openflow of-instance
PORT-CHANNEL FAILOVER-GROUP	DellEMC(conf-po-failover-grp)#	port-channel failover-group
PRIORITY GROUP	DellEMC(conf-pg)#	priority-group
PROTOCOL GVRP	DellEMC(config-gvrp)#	protocol gvrp
QOS POLICY	DellEMC(conf-qos-policy-out-ets)#	qos-policy-output
SUPPORTASSIST	DellEMC(support-assist)#	support-assist
VLT DOMAIN	DellEMC(conf-vlt-domain)#	vlt domain
VRRP	DellEMC(conf-if-interface-type-slot/port-vrid-vrrp-group-id)#	vrrp-group
u-Boot	Dell=>	Press any key when the following line appears on the console during a system boot: Hit any key to stop autoboot:
UPLINK STATE GROUP	DellEMC(conf-uplink-state-group-groupID)#	uplink-state-group

The following example shows how to change the command mode from CONFIGURATION mode to PROTOCOL SPANNING TREE.

DellEMC(conf)#protocol spanning-tree 0
DellEMC(config-span)#