Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

address-family

Enable the IPv4 multicast or the IPv6 address family.

Syntax
address-family {ipv4 multicast | ipv6 unicast} [vrf vrf-name]
Parameters
ipv4 multicast
Enter the keyword ipv4 followed by the keyword multicast to enable BGPv4 multicast mode.
vrf vrf-name
Enter the keyword vrf and then the name of the VRF to enable VRF mode.
NOTE: It is not be possible to enable VRF mode for IPv6 unicast without configuring the corresponding IPv4 unicast mode for the same VRF. While deletion, whenever the IPv4 VRF mode is deleted for the VRF, Dell EMC Networking OS automatically deletes the IPv6 VRF configurations as well.
ipv6 unicast
Enter the keyword ipv6 followed by the keyword unicast to enable BGPv6 mode.
Defaults
Not configured.
Command Modes
ROUTER BGP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.8(2.0)
Introduced on the S3100 series.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for IPv6 VRF.
9.4.(0.0)
Added support for VRF.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
6.5.1.0
Introduced

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\