Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

application (for HTTP and ICMP)

Configure the management egress interface selection for HTTP and ICMP.

NOTE: Only the options that have been newly introduced are described here. For a complete description on all of the keywords and variables that are available with this command, refer the respective Command Reference Guide of the applicable platform of the Release 9.2(0.0) documentation set.

Syntax
application {all | application-type}

To remove a management application configuration, use the no application {all | application-type} command.

Parameters
application-type
Enter any of the following keywords:
  • For HTTP, enter the keyword http.
  • For ICMP, enter the keyword icmp.
all
Configure all applications.
Defaults
None.
Command Modes
EIS Mode (conf-mgmt-eis)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.3.(0.0)
Added support for the HTTP and ICMP traffic on the Z9000, S4810, and S4820T.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\