Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

bgp redistribute-internal

Redistribute internal Border Gateway Protocol (iBGP) routes into and IGP such as OSPF and IS-IS.

Syntax
bgp redistribute-internal

To disable iBGP redistribution, use the no bgp redistribute-internal command.

Defaults
Not configured.
Command Modes
  • ROUTER BGP
  • ROUTER BGP-address-family
  • ROUTER BGP-address-family-IPv6
  • IPv4 VRF mode
  • IPv6 Unicast VRF mode
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.14(0.1)
Introduced on the S3048–ON, S4048–ON, S4048T-ON, S6010–ON, and Z9100–ON.
Usage Information

After configuring the bgp redistribute-internal command, use the clear ip bgp * command to clear all BGP sessions. If you don’t clear all BGP sessions, route redistribution happens only for new routes.

NOTE: When you enable redistribution of iBGP routes into an IGP, ensure that you use route maps to control what prefixes are redistributed. Redistributing all iBGP routes can create a loop in the network.
Example
Router(config)# router ospf 10
Router(config-router_ospf)# redistribute bgp 10 route-map bgp_2_ospf
Router(config-router_ospf)# exit
DellEMC(conf)# router bgp 10
DellEMC(conf-router_bgp)# bgp redistribute-internal
Caution: Might cause routing loops; please use prefix-list to restrict the prefixes
Router(config-router_bgp)# end
Router# clear ip bgp

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\