Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

clear ip dhcp

Reset the DHCP counters.

Syntax
clear ip dhcp [binding {address} | conflict | server statistics]
Parameters
binding
Enter the keyword binding to delete all entries in the binding table.
address
Enter the IP address to clear the binding entry for a single IP address.
conflicts
Enter the keyword conflicts to delete all of the log entries created for IP address conflicts.
server statistics
Enter the keywords server statistics to clear all the server counter information.
Defaults
None
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Introduced on the C-Series and S-Series.
Usage Information
Press Enter after the clear ip dhcp binding command clears all the IPs from the binding table.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\