Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

clear ipv6 route

Clear (refresh) all or a specific route from the IPv6 routing table.

Syntax
clear ipv6 route [vrf vrf-name] {* | ipv6-address prefix-length}
Parameters
vrf vrf-name
(Optional) Enter the keyword vrf followed by the name of the VRF to clear the IPv6 routes corresponding to that VRF.
*
Enter the * to clear (refresh) all routes from the IPv6 routing table.
ipv6-address prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.8(2.0)
Introduced on the S3100 series.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for VRF.
9.2(1.0)
Introduced on the Z9500.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
8.2.1.0
Introduced on the E-Series.
7.8.1.0
Introduced on the C-Series and S-Series.
7.4.1.0
Introduced on the E-Series.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\