Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

da-rsp-timeout

Configure timeout value for the back end task to respond to DAC requests.

Syntax
da-rsp-timeout minutes

To undo the configuration, enter the no da-rsp-timeout command.

Defaults
10 Minutes.
Parameters
minutes
Enter the time out value.
Command Modes
  • CONF-DYNAMIC-AUTH
Usage Information
  • Time for DAS to wait before the back end response is received.
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

The following is a list of the Dell EMC Networking OS version history for this command.

Version
Description
9.14(1.0)
Introduced on the S4810 and S4820T.
9.13(0.0)
Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000, S6010–ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and MXL.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\