Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

dcb-enable

Enable data center bridging.

Syntax
dcb enable[pfc-queues 1–4]

To disable DCB, use the no dcb enable command.

Parameters
pfc-queues
Enter the pfc-queue range. To disable DCB, use the no dcb enable command. The range is from 1 to 4.
Defaults
None
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
9.7(0.0)
Introduced on the S6000-ON and Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information

By default, iSCSI is enabled on the unit and the flow control is enabled on all of the interfaces. It is also acts as defaults when the link-level flow control is enabled on one or more interfaces.

Enables priority flow control or enhance transmission selection on interface.

Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\