Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

debug dcbx

Enable DCBX debugging.

Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail | mgmt | resource | sem | tlv}

To disable DCBX debugging, use the no debug dcbx command.

Parameters
{all | auto-detect-timer | config-exchng | fail | mgmt | resource | sem | tlv}
Enter the type of debugging, where:
  • all: enables all DCBX debugging operations.
  • auto-detect-timer: enables traces for DCBX auto-detect timers.
  • config-exchng: enables traces for DCBX configuration exchanges.
  • fail: enables traces for DCBX failures.
  • mgmt: enables traces for DCBX management frames.
  • resource: enables traces for DCBX system resource frames.
  • sem: enables traces for the DCBX state machine.
  • tlv: enables traces for DCBX TLVs.
Defaults
None
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0)
Introduced on the S3048-ON and S4048-ON.
9.7(0.0)
Introduced on the S6000-ON and Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\