Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

debug ip bgp updates

Allows you to view information about BGP updates.

Syntax
debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group peer-group-name] updates [in | out | prefix-list prefix-list-name]

To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group peer-group-name] updates [in | out | prefix-list prefix-list-name] command.

Parameters
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view BGP updates information corresponding to that VRF.
A.B.C.D
(OPTIONAL) Enter an IPv4 address of the neighbor.
X:X:X:X::X
(OPTIONAL) Enter an IPv6 address.
peer-group peer-group-name
(OPTIONAL) Enter the keyword peer-group followed by the name of the peer group.
in
(OPTIONAL) Enter the keyword in to view only BGP updates received from neighbors.
out
(OPTIONAL) Enter the keyword out to view only BGP updates sent to neighbors.
prefix-list prefix-list-name
(OPTIONAL) Enter the keyword prefix-list then the name of an established prefix list. If the prefix list is not configured, the default is permit (to allow all routes).
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
(OPTIONAL) Enter the name of the peer group to disable or enable all routers within the peer group.
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for VRF.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.7.1.0
Introduced on the C-Series.
Usage Information

To remove all configured debug commands for BGP, enter the no debug ip bgp command.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\