Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

debug ipv6 pim

Invoke IPv6 PIM debugging.

Syntax
debug ipv6 pim [vrf vrf-name] [bsr | events | group [group] | packet [in | out] | register [group] | state | timer [assert | hello | joinprune | register]]

To disable IPv6 PIM debugging, use the no debug ipv6 pim [vrf vrf-name] command.

Parameters
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view IP PIM debugging messages corresponding to that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
bsr
(OPTIONAL) Enter the keyword bsr to invoke debugging of IPv6 PIM Candidate RP/BSR activities.
events
(OPTIONAL) Enter the keyword events to invoke debugging of IPv6 PIM events.
group [group]
(OPTIONAL) Enter the keyword group followed by the group address to invoke debugging on that specific group.
packet
(OPTIONAL) Enter the keyword packet to invoke debugging of IPv6 PIM packets.
register [group]
(OPTIONAL) Enter the keyword register and optionally the group address to invoke debugging of IPv6 PIM register messages for a particular group.
state
(OPTIONAL) Enter the keyword state to view IPv6 PIM state changes.
timer [assert | hello | joinprune | register]
(OPTIONAL) Enter the keyword timer to view IPv6 PIM timers. Enter one of the optional parameters:
  • assert: to view the assertion timer
  • hello: to view the IPv6 PIM neighbor keepalive timer
  • joinprune: to view the expiry timer (join/prune timer)
  • register: to view the register suppression timer
Defaults
Disabled.
Command Modes
EXEC Privilege
Command History
Version
Description
9.11.3.0
Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100, S6010-ON, S3048-ON, and C9010.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\