Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

debug uplink-state-group

Enable debug messages for events related to a specified uplink-state group or all groups.

S4048–ON

Syntax
debug uplink-state-group [group-id]

To turn off debugging event messages, enter the no debug uplink-state-group [group-id] command.

Parameters
group-id
Enables debugging on the specified uplink-state group. The valid group-id values are from 1 to 16.
Defaults
none
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10.0.2
Introduced on the Z9100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.10(0.0)
Introduced on the S3148.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.4.2.3
Introduced on the S-Series S50.
Related Commands
  • clear ufd-disable — re-enable downstream interfaces that are in a UFD-Disabled Error state.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\