Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

delay-restore abort-threshold

Increase the boot up timer to a value greater than 60 seconds.

Syntax
delay-restore abort-threshold <interval>

To remove the boot up timer value, use the no delay-restore abort-threshold command.

Parameters
interval
Enter the interval value (in seconds) for the delay restore timer to abort. The range is from 1 to 1800 seconds. The default is 60 seconds.

This delay restore timer applies only during reload/boot-up and not in other scenarios (for example, during ICL flap).

Defaults
60 seconds
Command Modes
VLT DOMAIN
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S4820T, S4810, S6000, S5000, Z9000, S6000–ON and Z9500.
Usage Information
To abort the VLT delay restore timer value as the maximum threshold, during reload, apply the maximum time interval to the hold-down ICL peer-up in the start-up configurations.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\