Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

distribute-list out

Configure a filter for outgoing routing updates.

S4048–ON

Syntax
distribute-list prefix-list-name out [interface | bgp | connected | isis |ospf | static]

To delete the filter, use the no distribute-list prefix-list-name out command.

Parameters
prefix-list-name
Enter the name of a configured prefix list.
interface
(OPTIONAL) Identifies the interface type slot/port as one of the following:
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
  • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
  • For a Port Channel interface, enter the keywords port-channel then a number.
  • For a VLAN, enter the keyword vlan then a number from 1 to 4094.
connected
(OPTIONAL) Enter the keyword connected to filter only directly connected routes.
isis
(OPTIONAL) Enter the keyword isis to filter only IS-IS routes.
ospf
(OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static
(OPTIONAL) Enter the keyword static to filter manually configured routes.
Defaults
Not configured.
Command Modes
ROUTER RIP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100-ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.5.1.0
Added support for 4-port 40G line cards on the E-Series.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.6.1.0
Introduced on the C-Series.
pre- 6.2.1.1
Introduced on the E-Series.
Related Commands
  • ip prefix-list — enters PREFIX-LIST mode and configures a prefix list.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\