Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

dot1x profile

Configure a dot1x profile to define a list of trusted supplicant MAC addresses.

Syntax
[no] dot1x profile profile-name
Parameters
profile-name
Enter a dot1x profile-name. The profile name length is limited to 32 characters.
Defaults
None
Command Modes

CONFIGURATION

CONFIGURATION TERMINAL BATCH

Error Strings
NONE
Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S3100 series, S4048–ON, S4048–ON, S4810, S4820T, S5000, S6000, S6000–ON, S6100–ON, the Configuration Terminal Batch mode on C9010, Z9100–ON, and Z9500.
9.9(0.0)
Introduced on the C9010.
Usage Information

The dot1x profile command configures a dot1x profile to define a list of trusted supplicant MAC addresses. Maximum number of dot1x profiles is limited to 10. This command launches dot1x profile mode for entering profile related commands such as the mac command. The dot1x static-mab command assigns the dot1x profile to an interface.

Use this command in Configuration Terminal Batch mode to configure the dot1x profile in a dual-homing setup.

Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\