Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

enable xfp-power-updates

Enable 10–gigabit small form-factor pluggable (XFP) power updates for SNMP.

Syntax
enable xfp-power-updates interval seconds
Parameters
interval seconds
Enter the keyword interval then the polling interval in seconds. The range is from 120 to 6000 seconds. Default: 300 seconds (5 minutes).
Defaults
Disabled
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide.

Version
Description
8.3.19.0
Deprecated command for S4820T. Replaced by the enable optic-info-update interval command to update information on temperature and power monitoring in the SNMP MIB.
8.3.11.4
Deprecated command for Z9000. Replaced by the enable optic-info-update interval command to update information on temperature and power monitoring in the SNMP MIB.
8.3.10.0
Deprecated command for the S4810 only. Replaced by the enable optic-info-update interval command to update information on temperature and power monitoring in the SNMP MIB.
8.1.1.0
Introduced on the E-Series.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series and E-Series.
Usage Information
The chassis MIB contains the entry chSysXfpRecvPower in the chSysPortTable table. Periodically, IFA polls the XFP power for each of the ports and sends the values to IFM where it is cached.

To enable polling and to configure the polling frequency, use this command.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\