Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

enable

Enable uplink state group tracking for a specific UFD group.

Syntax
enable

To disable upstream-link tracking without deleting the uplink-state group, use the no enable command.

Defaults
Upstream-link tracking is automatically enabled in an uplink-state group.
Command Modes
UPLINK-STATE-GROUP
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10.0.2
Introduced on the Z9100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.10(0.0)
Introduced on the S3148.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.2(1.0)
Introduced on the Z9500.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only.
8.3.19.0
Introduced on the S4820T
8.3.12.0
Introduced on the S4810.
8.4.2.3
Introduced on the S-Series S50.
Related Commands
  • uplink-state-group — create an uplink-state group and enables the tracking of upstream links.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\