Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

enable

Enable a specific SupportAssist activity.

Syntax
enable

To disable a particular SupportAssist activity, use the no enable command.

Defaults
Enabled
Command Modes

SUPPORTASSIST ACTIVITY FULL-TRANSFER

SUPPORTASSIST ACTIVITY CORE-TRANSFER

SUPPORTASSIST ACTIVITY EVENT-TRANSFER

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.11(0.0)
Introduced on the M I/O Aggregator and FN IOM.
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
9.9(0.0)
Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON, Z9500, MXL.
Usage Information
Enter the specific SupportAssist activity mode and then enable it.
NOTE: By default, the full transfer includes the core files. When you disable the core transfer activity, the full transfer excludes the core files.
Related Commands
  • activity — move user to the SupportAssist Activity mode for that activity.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\