Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

exec-timeout

Set a time interval that the system waits for input on a line before disconnecting the session.

Syntax
exec-timeout minutes [seconds]

To return to default settings, use the no exec-timeout command.

Parameters
minutes
Enter the number of minutes of inactivity on the system before disconnecting the current session. The range is from 0 to 35791. The default is 10 minutes for the console line and 30 minutes for the VTY line.
seconds
(OPTIONAL) Enter the number of seconds. The range is from 0 to 2147483. The default is 0 seconds.
Defaults
10 minutes for console line; 30 minutes for VTY lines; 0 seconds
Command Modes
LINE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.12.0
Introduced on the S4810.
8.3.11.1
Introduced on the Z9000.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
E-Series
Original command.
Usage Information
To remove the time interval, enter exec-timeout 0 0.
Example
Dell con0 is now available
Press RETURN to get started.
DellEMC>

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\