Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ip ecmp-group

Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when maximum paths are not configured, the CAM can hold a maximum of 16 ecmp per route.

Syntax
ip ecmp-group {maximum-paths | {number} {path-fallback}

To negate a command, use the no ip ecmp-group maximum-paths {number} command.

Parameters
maximum-paths
Specify the maximum number of ECMP for a route. The range is 2 to 64.
path-fallback
Use the keywords path-fallback to enable this feature. If you enable the feature, re-enter this keyword to disable the feature.
Defaults
16
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
9.0.0.0
Introduced on the Z9000.
8.3.10.0
Introduced on the S4810.
Usage Information
You must save the new ECMP settings to the startup-config (write-mem) then reload the system for the new settings to take effect.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\