Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ip ftp vrf

Configures an FTP client with a VRF that is used to connect to the FTP server.

Syntax
ip ftp [vrf {vrf-name | management}]

To undo the FTP client configuration, use the ip ftp [vrf vrf-name] command.

Parameters
vrf-name
Enter the vrf-name to specify the VRF that is used by the FTP client.
management
Enter the keyword management to specify that the VRF used by the FTP client is a management VRF.
Defaults
Disabled
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.0)
Introduced on the Z9500.
9.4(0.0)
Introduced on the S-Series and Z9000.
Usage Information
Use this command to make the FTP clients VRF-aware. The VRF name that you specify is used by the FTP client to reach the FTP server. If no VRF name is specified, then the default VRF is used.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\