Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ip host

Configures a mapping between the host name server and the IP address for a specific VRF. This mapping information is used by the name-to-IP address table to resolve host names.

Syntax
ip host [vrf vrf-name] name ip-address

To undo the host name server to IP address mapping for VRFs, use the no ip host [vrf vrf-name] name ip-address command.

Parameters
vrf vrf-name
(Optional) Enter the key word vrf and then the name of the VRF to configure the name server to IP address mapping for that VRF.
name
Enter the name od the host to be associated with an IP address.
ip-address
Enter the IP address of the name server in dotted decimal format.
Defaults
None
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.4.(0.0)
Introduced on the S-Series and Z-Series.
Usage Information
Use this command to create a mapping between a host name server and its IP addresses for a specific VRF.
Example
DellEMC(conf)# ip host vrf jay dell 1.1.1.1

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\