Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ip max-routes

Enables you to configure the maximum number of protocol routes per VRF that are allowed for IPv4.

Syntax
ip max-routes [vrf vrf-name] max-number
Parameters
vrf vrf-name
Enter the keyword vrf and then the name of the VRF for which you want to configure maximum number of protocol routes that IPv4 allows.
max-number
Enter the maximum number of protocol routes that a VRF RTM can hold. The range is from 0 to 7500.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.8(2.0)
Introduced on the S3100 series.
9.4.(0.0)
Introduced on the S4810 and S4820T.
Usage Information
Use this command to specify the maximum number of protocol routes that the Route Table Manager can hold for a specific VRF. This command does not apply to the management VRFs.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\