Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ip mroute

Assign a static mroute.

Syntax
ip mroute [vrf vrf-name] destination mask {ip-address | null 0| {{bgp| ospf} process-id | isis | rip | static} {ip-address | tag | null 0}} [distance]

To delete a specific static mroute, use the no ip mroute [vrf vrf-name] destination mask {ip-address | null 0| {{bgp| ospf} process-id | isis | rip | static} {ip-address | tag | null 0}} [distance] command.

To delete all mroutes matching a certain mroute, use the no ip mroute [vrf vrf-name]destination mask command.

Parameters
vrf vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to assign a static mroute to that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.
destination
Enter the IP address in dotted decimal format of the destination device.
mask
Enter the mask in slash prefix formation ( /x ) or in dotted decimal format.
null 0
(OPTIONAL) Enter the keyword null then zero (0).
[protocol [process-id | tag] ip-address]
(OPTIONAL) Enter one of the routing protocols:
  • Enter the BGP as-number then the IP address in dotted decimal format of the reverse path forwarding (RPF) neighbor. The range is from 1 to 65535.
  • Enter the OSPF process identification number then the IP address in dotted decimal format of the RPF neighbor. the range is from 1 to 65535.
  • Enter the IS-IS alphanumeric tag string then the IP address in dotted decimal format of the RPF neighbor.
  • Enter the RIP IP address in dotted decimal format of the RPF neighbor.
static ip-address
(OPTIONAL) Enter the Static IP address in dotted decimal format of the RPF neighbor.
ip-address
(OPTIONAL) Enter the IP address in dotted decimal format of the RPF neighbor.
distance
(OPTIONAL) Enter a number as the distance metric assigned to the mroute. The range is from 0 to 255.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for VRF. Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
E-Series legacy command
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\