Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ip telnet vrf

Configures a TELNET client to use a specific VRF.

Syntax
ip telnet [vrf vrf-name]

To undo the TELENT client configuration, use the ip telnet [vrf vrf-name] command.

Parameters
vrf vrf-name
Enter the keyword vrf and then the name of the VRF to specify the VRF that is used by the TELENT client.
Defaults
Disabled
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant FTOS Command Line Reference Guide.

Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.0)
Introduced on the Z9500.
9.4.(0.0)
Introduced on the S-Series and Z9000.
Usage Information
If you configure a TELNET client to use a specific VRF, then you need not explicitly specify the same VRF during the TELNET client sessions corresponding to that VRF.
Example
Dell(conf)# ip telnet vrf vrf1 
Dell(conf)# do telnet 10.10.10.2 
Dell(conf)# no ip telnet vrf vrf1
Dell(conf)#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\