Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ip tftp vrf

Configures an TFTP client with a VRF that is used to connect to the TFTP server.

Syntax
ip tftp [vrf vrf-name]

To undo the TFTP client configuration, use the no ip tftp [vrf vrf-name] command.

Parameters
vrf vrf-name
Enter the keyword vrf and then the name of the VRF to specify the VRF that is used by the TFTP client.
Defaults
Disabled
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.0)
Introduced on the Z9500.
9.4.(0.0)
Introduced on the S-Series and Z9000.
Usage Information
Use this command to make the TFTP clients VRF aware. The VRF name that you specify is used by the TFTP client to reach the TFTP server. If no VRF is specified, then the default VRF is used.
Related Commands

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\