Dell Command Line Reference Guide for the S4048–ON System 9.14.2.5

PDF

ipv6 access-list

Configure an access list based on IPv6 addresses or protocols.

Syntax
ipv6 access-list access-list-name cpu-qos

To delete an access list, use the no ipv6 access-list access-list-name command.

Parameters
access-list-name
Enter the access list name as a string, up to 140 characters.
cpu-qos
Enter the keyword cpu-qos to assign this ACL to control plane traffic only (CoPP).
permit
Enter the keyword permit to configure a filter to forward packets meeting this condition.
deny
Enter the keyword deny to configure a filter to drop packets meeting this condition.
ospfv3
Specify that this ACL is for OSPFv3 control plane traffic
Defaults
All access lists contain an implicit “deny any”; that is, if no match occurs, the packet is dropped.
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.4(0.0)
Added support for CoPP for OSPFv3 on the S4810, S4820T, S6000, and Z9000 platforms.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000
8.3.11.1
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.3.7.0
Introduced on the S4810.
8.4.2.1
Introduced on the S-Series.
8.2.1.0
Introduced on the E-Series.
7.8.1.0
Introduced on the C-Series. Increased the name string to accept up to 140 characters. Prior to version 7.8.1.0, names are up to 16 characters long.
7.4.1.0
Introduced on the E-Series.
Usage Information
The number of entries allowed per ACL is hardware-dependent. For detailed specification on entries allowed per ACL, refer to your line card documentation. You can create an IPv6 ACL for control-plane traffic policing for OSPFv3, in addition to the CoPP support for VRRP, BGP, and ICMP.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\